. MAINTENANCE SERVICE PROCEDURE CHECK LEVEL OF REFRIGERANT WARNING 4 - 41 REPLACE AIR CON DITIONER BELT 1. Loosen 4 bolts to the side. 2. Replace the V When adjus directly with 3. Tighten jack b V-belt. The st (0.4 in) when kg) at a point m pulley and fan (1) and jack bolt (2), then move compressor (3) -belt. ting the V-belt, do not push the compressor the bar. Use jack bolt (2). olt (2) and bolts (1), and apply andard deflection for the belt is pressed with a finger force of a tension to the approx. 10 mm pprox. 58.8N (6 idway between the air conditioner compressor pulley.
If the refrigerant use d in the air conditioner gets into you r eyes or on your hands, it may cause l oss of sight or frostbite. Do not tou ch the refrigerant. Never loosen any pa rt of the refrigerant circuit. me close to any point where the refrigerant gas is Do not bring any fla leaking. If the level of the r efrigerant (gas) is low, the cooli ng effect will be reduced. Run the engine at high idle, and check the flow of the refrigerant gas (R1 34a) in the refrigerant circuit th rough the sight glass (2) (inspectio n window) of the receiver (1) wh en the cooler is running at high sp eed.
bubbles are included in the flow s are included in the flow es pass continuously) less, transparent (A) Correct: No bubbles are included in the flow (B) Low: Bubble (bubbl (C) None: Color REMARK When there ar e bubbles, the refrigerant gas level is low, so contact your ref air conditioner cause damage rigerant dealer to have refrigera nt added. If the is run with the refrigerant gas level low, it will to the compressor. sed as the refrigerant. New R134a is u OPERATING AIR CONDITIONER OFF-SEASON Even during the off -season, operate the air conditi oner for 3 to 5 minutes once a month to m aintain the oil film at al parts of the compr essor.