Komatsu — EVERY 250 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE EVERY 250 HOURS SERVICE indicate the greasing points for multi-shank 4 - 47 LUBRICATING 1. Lower t he work equipm ent to the ground , then stop the engine. 2. Using a grease pump, p ump in grease t hrough the grease fittings 3. After gr easing, wipe off any old grease t hat was pushed out.

(1) Blade lif t cylinder suppo rt yoke (4 places REMARK These are at the front and r ear of the left an d right cylinders (2) Blade lif t cylinder suppo rt shaft (2 places (3) Blade a rm ball joint (4 p (4) Brace s (5) Ripper l ift cylinder botto m pin (2 places) (6) Ripper l ift cylinder rod e nd pin (2 places) (7) Ripper arm pin (front) (6 places) places) (8) Ripper arm pin (rear) (6 ( 5) - (8) r ipper sp the fixe