Komatsu — EVERY 1000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE REPLACE HYDRAULIC TANK BREATHER ELEMENT WARNING then remove cap (1). 4 - 61 The parts and oil are at high te mperature immediately after the engine is stopped, and may cause burns. Wait for the ork. temperatur e to go down b efore st arting the w When remo ving the oil fill er cap, oi l may spur t out, so push t he cap down to release the internal pressure, then remove t he cap carefully. 1. Push do wn cap (1) of oil filler (F) to rele ase the air an d remove nal pressure. 2. Keep ca p (1) pushed 3. Remove ring (2) from inside t he lip of c ap (1). 4. Remove 5. Replace filter elemen 6. Install va lve (3) and ri ng (2) i n their ori ginal position 7.

Install ca stalling cap ( 1) to the tank, pu sh it down, th en tur n it REMARK not installed correctly, it will cause leakage of oil. If the cap is not installed correctl y, it will ca use leakage of oil. When install ing the cap, press th e cap do wn, and turn it until i t is securely in contact w ith the stopper. The cap is t he lock additi on type. About handl ing method o f cap wi th the loc k, see " CAP WITH