. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE 4 - 65 9. 10. Loose Loose n air bleed p n wing nut ( lug (3) 6) of lev Push i Check n lever (5) r that bubble epeated s come ly. out with the fuel from air bleed plu (3). Tighte Tightening torque: 4.9 to 6 13. Tighte n wing nut ( 6) secur ely to lock lever (5) in Target tightening torque: 2 to 3 Nm 0.2 to 0.3 kgm 14. After r eplacin g the filter ca rtridge, sta rt the engin e and run it at low idling for 10 minutes . Check the filte r se al surfa ce for oil le akage . If an y leakage o f oil is found, check the tigh tening condition of the filter ca rtridge.
If t here is s till leakage of oil, repea t Steps 1 - 3 to remove the cartridge, th en check the cartridge. If there is any damage to th e packing surfac e or e mbeddedfo reign material, replace the c artridge with a new part and re peat the procedure for Steps 4 - 14.