Komatsu — EVERY 2000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE (B): 25mm (1 in) 4 - 69 2. Remove the undercover (1) at the bottom rear of the c hassis as follows. (A): Machine's right sid 1) Remove 2 bolts (2) 2) Hold cover (1) in po at the Left of mach doing this.) 3) Lower cover (1) slo right side of the cov Drain plug (P) can b follows. e at the Right of machine. (A): Machine's right sid 1) Remove 2 bolts (2) 2) Hold cover (1) in po sition and gradually remove 2 bolts (3) ine. (Rain water may flow out when wly to open it. (There is a hinge on the er.) e seen at the top. 3. Remove dipstick (G), th en remove drain plug (P) and drain the oil. After draining the oil,tig hten drain plug (P). 4.

Add oil through the hold er of dipstick (G). After adding the oil, 5. insert dipstick (G). Wipe away dust around the breather (4). 6. Remove breather (4). 7. Remove any dirt or dus t stuck to breather (4), then w ash w ith clean diesel oil or fl ushing oil.If it cannot be cleaned a new part. completely, replace with 8. Install the breather (4). Then close cover (1). 9. CHECK PIVOT BEARIN G OIL LEVEL, ADD OIL 1. Remove plug (1). 2. Check that oil is at oil le vel (A). If not, refill with oil th rough oil filler plug (1). (The oil sh ould be TO30 (SAE 30) irrespective of an atmospheric temper ature.)