. MAINTENANCE SERVICE PROCEDURE pressure of has gone down. Please contact your Komatsu METHOD OF RELEASING PRESSURE IN HYDRAULIC CIRCUIT NOTICE (A) (B) (C) (D) (E) RAISE LOWER FLOAT LEFT TILT RIGHT TILT CHECK ALTERNATOR Contact your Komatsu distributor to have the alternator checked. If the engine is started frequently, have this inspection carried out every 1000 hours. CHECK ENGINE VALVE CLEARANCE, ADJUST Special tools are needed for inspection and maintenance, so contact your Komatsu distributor. 4 - 72 In distributor.
Work eq uipment d oes not g Stops w hile going he accumulato Finish the ste ps of operating the b lade control lever to the front a nd back, and to th e right and left, to eac h stroke end with in 15 seconds afte r the engin e has stopp ed. After the engine stops, pressure inside the accumulato r begins to gradually go dow n, so the pressure cannot be released e xcept right af ter the engine stops. 1. Lower t he work e quipment and stop th e engine. 2. Turn the starting switch to the ON pos 3. Set the work equipment loc k lever to t he FREE 4. Operate the blad e control l ever fully to the front, rear, l eft, and right to release th e pressur e from the hydraulic circuit.
When r eleasing t he pressu re from the hydraulic rippe r circuit, operate the rippe r control l ever fully to the left and r igh t (i n the case of the fixed multi-sha nk ripper) o r to th e fr on t, r ear, left, and righ t (in the c ase of the variable m ulti-shank ripper). 5. Set the work equipment loc k lever to t he LOCK