OPERATION 3.5 CAMERA SYSTEM WITH MONITORS 3.5.1 LOCATION OF MONITORS AND CONTROL UNITS Legend for illustration Z25564 - I - Top view of Operator’s cab (A) Components of the camera system mounted on the cab base, see page 139 for details.
(B) Components of the camera system mounted on the right side of the counterweight (C) Components of the camera system mounted on the left side of the counterweight (1) Monitor for viewing the right and left front track area (2) Monitor for viewing the right rear area of the excavator (3) Monitor for viewing the left rear area of the excavator (4) Control unit for monitor (1) (5) Control unit for monitor (2) (6) Control unit for monitor (3) (7) Ball joint housing (8) Clamping screw Adjust the position of the monitors The monitors (1 - 3) are fastened by means of ball joints and can be adjusted in any direction.
To adjust the position of the monitor loosen the clamping screw (8) at the ball joint housing (7) and move the monitor into a suitable position. Retighten the clamping screw securely by hand. Refer to page 135 for operating instructions of the monitors. 133