Komatsu — 3.8.2 SWITCH BOARD (X2) IN CAB BASE

OPERATION 3.8 ELECTRICAL EQUIPMENT IN CAB BASE 3.8.2 SWITCH BOARD (X2) IN CAB BASE Legend for illustration Z25517 Switches (S27) Emergency By-pass switch for the shutdown function of the PLC (E6). If an automatic shutdown is initiated by Shovel systems, with a dangerous situation for man or machine, which needs the Shovel to be operable to over-come the dangerous situation, actuate this switch to override the shutdown function of the system and to enable a restart of the Diesel engine. NOTICE This switch can not override engine initiated shutdowns. As soon as the immediate situation of danger is over, shutdown the unit.

Cor- rect the fault that caused the shut down and re-set the Emergency By-pass switch (S27). (S41.1) Switch for constant engine speed adjustment to 1800/min (rated speed) for testing pur- poses (S97) Switch for upload of new program to VHMS controller (E46), refer to VHMS Service Manual for more information. Service Switch for ”QMIN” and ”QMAX” Control of the Main Hydraulic Pumps The Service switch (S155) is used for testing and adjusting procedures of the hydraulic system and should only be oper- ated through authorized service personnel (S155) Service switch for Qmin/Qmax position of main hydraulic pumps. Switch positions: 0 - Normal operating position 1 - Qmax position.

The main pumps remain in maximum delivery position. 2 - Qmin position. The main pumps remain in Qmin position, i.e. minimum oil delivery to the hydraulic system. NOTICE Make sure that the switch (S155) is switched off as soon as the testing and adjusting procedures of the hydraulic system are finished. (S145) Resetting switch for upper and lower windshield wiper After rectifying a trouble condition of the windshield wiper, operate this switch to reset the wiper system to operating condition. 157 CAUTION CAUTION