Komatsu — 3.8.2 SWITCH BOARD (X2) IN CAB BASE

OPERATION 3.8 ELECTRICAL EQUIPMENT IN CAB BASE Emergency Indication of Operating Conditions The VHMS system is equipped with an emergency indication via LED’s on the Programmable Logic Controller ”PLC” (E6), illust. (Z 22588). In case of a malfunction of the health monitor in the operator’s cab, the LED’s in the fourth column (A7/A12 and A8/E12) of the ”PLC” indicating failures in vital operating systems of the Shovel. The following faults are indicated: 163 Fault LED No. The VHMS system is by-passed (By-pass switch S27 actuated) H30 Start of engine blocked, resp. engine shifted to low idle speed by one or more of the four high pressure filters.

NOTICE The LED ”H31” monitors all four high pressure filters. Refer to page 165 for descrip- tion of the diagnostic codes flashed out by LED ”H31”. H31 Start of engine blocked, resp. engine shut down, due to closed main shut-off (gate) valve hydraulic tank H37 Faulty monitor channel for hydraulic oil temperature H38 Strainer oil cooler restricted H74 Faulty monitor channel engine speed H112 Emergency shut down switch actuated H116 Engine shutdown from ground man H135 Hydraulic oil level too low H137 VHMS Controller trouble H151 VHMS Display trouble H152