OPERATION 3.8 ELECTRICAL EQUIPMENT IN CAB BASE 3.8.3 COMPONENTS OF ELECTRICAL PREHEATING SYSTEM IN CAB BASE The cab base contains high voltage electrical appliances. Access to the cab base for authorized service staff only. General The preheating system is a special equipment and can be installed in the factory or locally at site. Power supply to the pre- heating system is provided by an external power source. The following systems are equipped with heaters: Engine cooling system Engine lubricating system Hydraulic system (main and suction oil reservoir) PTO (pump distributor gear) Storage batteries REMARK The auxiliary heater unit in the cab base (5), illust.
Z26083 and the battery charger (3) are also connected to the external power supply. Legend for illustration Z26083 (1) Main switch board (1X1) for the preheating systems, located in the cab base (2) Main switch (1Q1) for all system heaters (3) Battery charger (E55) (4) Circuit breaker 1F76 - 125A for battery charger (5) Heater unit (1H1) for cab base (6) Control box for hydraulic oil heating (7) Switch, hydraulic oil heating ON / OFF (8) Indicator light green, hydraulic oil heating ON. (9) Warning light red, heating system failure. (10) Main switch board (X2) 167 WARNING WARNING