Komatsu — 3.8.3 COMPONENTS OF ELECTRICAL PREHEATING SYSTEM IN CAB BASE

OPERATION 3.8 ELECTRICAL EQUIPMENT IN CAB BASE Pre-heating System (continued) Engine Coolant and Engine Oil Heatings REMARK Use the heating system during stand-still periods e.g. over night and low ambient temperatures. The heating system should be energized as soon as the engine is stopped. This allows the heating system to maintain the desired temperature with the use of minimum power.

Legend for illustration Z26084 (1) LH main frame member (90° turned to the left) (2) Coolant heater unit (3) Shut-off valve in coolant outlet line (4) Shut-off valve in coolant inlet line (5) Heater element in engine oil pan (6) Control box for coolant heating (7) Indicator light, coolant heating ON, (8) Switch, coolant heater ON/OFF. (9) Coolant heating element (10) Water pump with motor To activate the coolant heating, set main switch (1Q1) on the switch board in cab base to ON position. The coolant heating can then be switched on with switch (8) on the control panel. The lamp (7) illuminates with coolant heating ON. Before starting the shovel engine, switch OFF the cool- ant heater.

The coolant heating system must not be operated while the engine is running. If operated, premature element failure may result. REMARK For more information about the coolant heating system, refer to the operation manual COOLANT HEATING SYSTEM filed in volume 2 binder. 171 CAUTION CAUTION