OPERATION 3.9 CHECKS BEFORE STARTING THE ENGINE Before starting the Engine, make sure that no one will be endangered when starting the Engine. CHECK THE FOLLOWING ITEMS Legend for illustration Z 21613 (1) Engine oil reserve tank of the RESERVE system (2) Sight gauge reserve tank oil level (3) Eliminator engine oil filtration system (4) Centrifugal separator for engine oil (5) Engine oil pan dipstick oil level gauge (6) Oil filler tube for engine oil pan (7) Engine coolant radiator (8) Coolant sight gauge on radiator (9) Radiator pressure cap 1. WALK-AROUND INSPECTION Make a ”Walk-around” inspection of the Shovel. Refer to Mainte- nance Section 4. for the daily inspection items. 2.
Engine oil level in reserve tank and engine oil pan Check oil level with Shovel standing on level ground. Check oil level in reserve tank (1) on sight gauge (2). The oil level is correct when it is between the MAX and MIN mark on the sight gauge. If necessary add engine oil via service arm connector. For more information See "CENTRAL REFILLING SYS- TEM" on page 238. Check oil level in engine oil pan with the dipstick oil gauge (5). For accurate readings, the oil level should not be checked until the oil has settled into the oil pan after the engine has been shut down (about 5 minutes).
REMARK The oil level in the engine oil pan can vary between the MIN and MAX marking on gauge (5) depending on the operating con- dition of the reserve system when the engine was stopped. With sufficient oil in the reserve tank and with the reserve system in proper working order, there is no need to fill the engine oil pan even with the oil level at the MIN mark on gauge (5). If the oil level is below the MIN marking on the gauge, corrective action must be taken. Fill the reserve tank and check the reserve system. The function of the reserve system is monitored by an indicator light located on the "X2" switch board in the cab base. See page 157 for more information. 175 CAUTION CAUTION