Komatsu — 3.10.1 STARTING PROCEDURE

OPERATION 3.10 STARTING THE ENGINE 3.10.1 STARTING PROCEDURE If the ambient temperature is below -25°C proceed according to step 7 on next page. 1. Insert battery main switch keys and turn to operating position, refer to section 3.6 for the location of the battery main switches. REMARK Start the engine with the lock lever (9) illust. Z25965 in the fully rear LOCKED position. When the engine is running move the lock lever fully to the front in FREE position. 2. Insert key into main switch (1) and turn to operating position. NOTICE The high level alarm (2) must give an acoustic test signal. If the alarm fails to function, corrective action must be taken. 3. Observe health monitor (3).

Normally the initialization screen is displayed on the monitor, see page 99 for more informa- tion. 4. Set toggle switch (4) to low idle speed position. 5. Sound the signal horn (5). 6. Start the engine by turning starter switch (6). REMARK The engine is equipped with a prelubrication system which is activated by the starter switch (6). Turning and holding the switch in the start position sends current to the prelubrication starter solenoid which then pre lubricates the engine. This solenoid timer prevents current from flowing to the conventional starting motor until adequate oil pressure has been achieved in the cam oil rifle.

After a subsequent 3 second delay, current is then directed to the conventional starting motors for cranking the engine. Cold Weather Starting Aid Controlled Ether Injection The electronic control module (ECM) of the engine controls ether injection into the intake manifold while cranking if the engine is below a calibrated minimum coolant temperature or intake mani- fold temperature value. It will continue to inject ether until a cali- brated maximum engine speed has been reached. For more information refer to Engine Manual page 1-16. REMARK Never operate the starter longer than 30 seconds at a time in order to avoid damage.

If the engine does not start within the first 30 seconds, wait 2 minutes before cranking again. As soon as the engine is running, check health monitor (3), for information. 183 CAUTION CAUTION