OPERATION 3.10 STARTING THE ENGINE 7. Cold Weather Starting at ambient Temperatures below –25°C and to –40°C (continued) 7. Once the Engine is up to working temperature, switch OFF the remaining electrical preheating systems and, if an exter- nal power source is used, disconnect the power supply cable. Carefully start moving the attachment by operating controls very slowly. Follow the steps below: 7.1 Raise the attachment slightly off the ground and start by holding the clam closed function over relief. Keeping in mind not to hold over relief for long periods of time as it may damage the relief valve due to overheating.
7.2 After holding clam closed function over relief, slowly open clam and hold open function over relief. Continue working clam and holding over relief until the hydraulic oil temperature begins to rise and then proceed on to the bucket functions. 7.3 While holding the bucket functions over relief, continue to work the clam to keep the oil flowing through the circuit. 7.4 As the temperature of the hydraulic oil rises, move on to the stick and then to the boom functions, keeping other functions in motion as well. Once the hydraulic oil tem- perature is approximately +30°C, start adding swing functions into motion.
7.5 Once the hydraulic oil is close to working temperature swing over one track, raise the track off of the ground with the attachment, and slowly rotate the raised track to remove cold oil from the circuit. The running surfaces of track pads must not be obstructed with dirt, mud, or other debris. Once the track has been rotated in both directions for a few minutes, lower the track and repeat the same procedure with the opposite track. 8. Operate the Shovel normally but smoothly, avoiding shocks and jerky movements, as hydraulic hoses may burst when the outside ambient temperature is extremely low. Operators must be more careful as temperature goes down to the limit of –40°C. 9.
If during operation, the ambient temperature drops below –40°c, stop work, move the loader attachment in the correct parking position, shut down the engine and switch on the electrical preheating systems. REMARK Never operate the starter longer than 30 seconds at a time in order to avoid damage. If the engine does not start within the first 30 seconds, wait 2 minutes before cranking again. 10. As soon as the engine is running, check display (3) for mes- sages. 187