OPERATION 3.10 STARTING THE ENGINE After starting observe the following The VHMS System monitors the Shovel’s functions and pro- vides information about the appropriate operational data. If a FAULT message is displayed on screen (3), the acoustic warning signal (10) will sound simultaneously for approxi- mately 1 second. In such a case proceed according to the instructions of the displayed message. Warning buzzer (10) will sound continuously when the hydraulic oil level is too low. In this case, stop the engine, locate and correct the cause immediately. Fill up hydraulic oil to the correct level. 11.
After warming up of the engine, the speed can be increased by setting switch (4) to high idle speed position. NOTICE DO NOT idle the engine for excessively long periods. Long periods of idling, more than 10 minutes, can damage the engine because combustion chamber temperature drop so low the fuel will not burn completely. Tis will cause carbon to clog the injector spray holes and piston rings and can cause the valves to stick. Never let the engine run with disconnected batteries. This may cause alternator damage.
Emergency By-pass Switch for the Shut-down Function of the Programmable Logic Controller The emergency by-pass switch is located on the "X2" switch board in the cab base compartment and marked with "S27". If an automatic shutdown is initiated by Shovel systems, with a danger- ous situation for man or machine, which needs the Shovel to be operable to over-come the dangerous situation, actuate this switch to override the shutdown function of the system and to enable a restart of the Diesel engine. NOTICE This switch can not override engine initiated shutdowns. As soon as the immediate situation of danger is over, shut down the unit.
Correct the fault that caused the shut down and re-set the Emergency By-pass switch. 189 CAUTION CAUTION CAUTION CAUTION