Komatsu — 3.19.2 FUNCTIONS OF THE TRANSFER PUMP

OPERATION 3.19 TRANSFER PUMP FOR HYDRAULIC OIL A - Pumping the oil from the Suction Oil Reservoir (11) into the Main Oil Reservoir (continued) 6. The suction oil reservoir and the suction hoses are filled, when bubble free oil flows out at the vent plug openings on each main pump. Install vent plugs and tighten securely. 7. Check oil level in all main pump housings and vent the hydraulic pumps according to page 447 in the Maintenance Section 4. 8. Check oil level in the main reservoir. Fill up with new hydraulic oil as necessary. 9. Start the engine and run without load to allow trapped air to be removed from the hydraulic system.

DO NOT start the engine when the suction oil reservoir is empty. B - Pumping the Oil from the Return Oil Collector Pipe (12) and back-pressure valve pipe (13) into the Main Reservoir 1. To empty the collector pipe (12), open cock (2). 2. Switch on pump with switch (6). REMARK To prevent build-up of a vacuum in the return oil collector pipe or back-pressure valve pipe, open a vent plug on each pipe. 3. Observe oil level sight gauge at the main oil reservoir. As soon as the oil level remains constant the return oil collector pipe is empty. Now switch off the transfer pump (4). Close cock (2) and the vent plug on the collector pipe. 4. To empty the back-pressure valve pipe (13), open cock (3).

5. Switch on pump with switch (6). 6. Observe oil level sight gauge at the main oil reservoir. As soon as the oil level remains constant the back-pressure valve pipe is empty. Now switch off the transfer pump (4). Close cock (3) and the vent plug on the back-pressure valve pipe. DO NOT start the engine during servicing. 237 CAUTION CAUTION CAUTION CAUTION