Komatsu — 3.25.2 HYDRAULIC SYSTEM

OPERATION 3.25 TROUBLE SHOOTING 3.25.2 HYDRAULIC SYSTEM 259 Problem Probable cause Poor hydraulic system perfor- mance ● Hydraulic oil not at operating temperature. ● Engine speed too low. ● Reservoir low on oil ● Restrictions in lines ● Cooling circuit, pump control system and/or pilot control circuit defective. ● Internal leakage (control blocks, valves or power units.) ● Pressure lines twisted or kinked ● Spool not in full stroke. ● Relief valve defective, or out of adjustment. ● Worn cylinders. ● Defective hydraulic pump. Excessive oil temperature ● Low oil level ● Incorrect viscosity or type of oil ● Hydr. oil cooler clogged with dirt. ● Oil cooler fan defective or wrong speed.

● Cooling circuit defective ● Pump control system defective ● Spool not in full stroke. ● Internal leakage (control blocks, valves or power units) ● Worn pump components ● Job conditions (high temperature of materials being handeld) Jerky motion of power cylinders ● Piston rod bent ● Piston sticking ● Inside diameter of cylinder tube partially increased or scored ● Air in control circuit ● Oil too cold ● Valve spool sticking, centering springs defective ● Pump and/or engine control system defective ● Valve of power circuit defective Noise when slewing ● Inssufficient lubrication of slew ring gear and/or slewing connection.

● Slewing connection mounting bolts loose ● Drive pinion worn ● Slew gear bearings worn ● Sun gear or planetary pinions worn ● High pressure circuit valves defective ● Anti-caviation valves sticking Excessive oil foaming ● Air in hydraulic system ● Poor quality oil ● Excessive by-passing of oil over relief valves ● Pressure hoses badly twisted or kinked ● Restricted oil flow due to foreign matter ● Breather on the reservoir clogged. ● Relief valve improperly adjusted