Komatsu — 4.2 SAFETY PRECAUTIONS FOR MAINTENANCE

MAINTENANCE 4.2 SAFETY PRECAUTIONS FOR MAINTENANCE 4.2 SAFETY PRECAUTIONS FOR MAINTENANCE Before starting any lubrication or maintenance work read the Fundamental Safety Instructions on page 16. Park the Shovel at a safe place on level ground. Proceed according to the instructions on page 213 ”Parking the Shovel”. Lower the attachment flat onto the ground. Move all control levers to neutral position. Stop the engine and move all control levers through their shift positions to relieve the pressure in the hydraulic system. Refer to page 214 ”Stopping the Engine” for detailed descrip- tion of the stopping procedure.

Before any maintenance work is started, set the maintenance safety switch to 0 position. Refer to page 149 for location of the maintenance safety switch. In the 0 position the engine can not be started. Secure this position by inserting a padlock into the holes of the switch. Up to three padlocks can be attached to the holes provided. A warning plate ”CAUTION MACHINE MAINTENANCE” must be fixed in the Operator’s cab before any lubrication or maintenance work is started. NOTICE Some checks and adjustments can only be done with the engine running. For such jobs two men are necessary. Thereby, the controls must not be left unattended, while the other man carries out checks and adjustments.

The man in the operator’s seat must keep constant visual contact with the other one and they must agree on suitable communication signals before they start their work. Block the machine to prevent machine movement Always use safety devices to block hydraulic cylinders. Never rely on the machine hydraulic system to hold when working on the loader attachment. A hydraulic line or cylinder could fail or someone could accidently strike the control levers causing the loader to fall. Relieve all pressure in the hydraulic system before servicing the hydraulic system. Oily cloth and inflammable material must be removed from the machine. Clean the excavator before starting mainte- nance work.

Switch-off battery main switch and remove key, before work- ing on the electrical system. Work on the electrical system or equipment may only be car- ried out by a skilled electricians and in accordance with the applicable electrical engineering rules. 263