Komatsu — 4.7.2 SWING CIRCLE TOOTHING LUBRICATION

MAINTENANCE 4.7 WHEN NECESSARY 4.7.2 SWING CIRCLE TOOTHING LUBRICATION See illustration Z 20850 All teeth of the gear ring (3) must be completely covered with grease. If the machine is equipped with gear ring guard (6), remove covers (7) for swing circle teeth inspection. NOTICE If the automatic lubrication system of the swing circle toothing fails to function for more than four operating hours, bucket motion cut-off will occur. Repair the lubri- cation system as soon as possible to prevent damage to the gear ring, drive pinion (4) and lubrication pinion (5). As an interim measure lubricate the toothing with special adhesive spray grease, illust.

(Z 0148) or spread type adhesive grease as specified in the Parts Catalog. The spread type grease can be applied, for example, with a brush. Make sure that the multi-purpose grease of the swing cir- cle bearing does not come in contact with the teeth of the swing circle because this will diminish lubrication capa- bility of the swing circle teeth lubricant. If necessary remove excessive multi-purpose grease from the swing circle above the dust seal ring. 289