MAINTENANCE 4.8 EVERY 10 OPERATING HOURS OR DAILY CHECK GREASE INJECTORS Legend for illustration Z 19191 E Injectors for swing circle teeth lubrication (1) Indicator stem for visual indication of injector operation (2) Output adjusting screw (7) Swing circle (8) Swing gear drive pinion (9) Swing circle guard (10) Inspection cover for swing circle teeth Check operation of injectors “E” . If necessary lubricate manually, using spray grease. CORRECTIVE ACTIONS 1. Check to make sure grease supply through inlet line is pro- vided. 2. Disconnect the outlet line of the respective injector. 3. Operate the central lubrication system manually. A - If now the injector works, i.e.
cycle indicator stem (1) moves in and out the disconnected line or the grease passage at the lubrication point is damaged or blocked by foreign matter. Repair as necessary. B - If the injector does not work, i.e. cycle indicator stem (1) stationary, replace the respective injector. 4. Operate the central lubrication system and re-check opera- tion of the grease injectors. NOTICE If the failure is caused through a defective central lubrication system, manually lubricate at grease fittings (4) after removal of caps (3). 303