MAINTENANCE 4.9 EVERY 50 OPERATING HOURS OR WEEKLY Swing gears manufactured by "Siebenhaar" Legend for illustration Z 21656 (A) Position of oil level gauge for checking the oil levels (1) Swing gear (2) Brake housing (3) Compensator oil tank for swing gear (4) Oil level gauge for swing gear (5) Oil drain plug for motor adapter housing (6) Oil level gauge for motor adapter housing (7) Breather filter for brake housing (8) Oil level gauge for brake housing (9) Oil drain plug for brake housing (10) Breather filter CHECK SWING GEAR OIL LEVEL Remove oil level gauge (4) and wipe it clean. Insert the gauge but DO NOT screw in, see detail ”A”. Remove the gauge.
The oil level should be at the upper mark of gauge (4). If necessary add the specified gear oil through filler pipe. Remove breather filter (10). Blow out with compressed air from inside to outside and reinstall. CHECK BRAKE HOUSING OIL LEVEL Remove oil level gauge (8) and wipe it clean. Insert the gauge but DO NOT screw in, see detail ”A”. Remove the gauge. REMARK The upper mark on gauge (8) indicates the correct oil level with the oil hot. The lower mark indicates the correct oil level with the oil cold. With cold oil, the oil level should be at the lower mark of gauge (8). With hot oil, the oil level should be just below the upper mark of gauge (8).
If necessary add engine oil SAE 10 or hydraulic oil r HLP 32 through filler opening. DO NOT overfill the brake housing, other- wise the brake could be damaged due to overheating. Remove breather filter from pipe (7). Blow out with compressed air from inside to outside and reinstall. CHECK MOTOR ADAPTER HOUSING OIL LEVEL Remove oil level gauge (6) and wipe it clean. Insert the gauge but DO NOT screw in, see detail ”A”. Remove the gauge. The oil level should be at the upper mark of gauge (6). If necessary add engine oil SAE 10 or hydraulic oil HLP 22 or HLP 32 through filler opening. 315