MAINTENANCE 4.9 EVERY 50 OPERATING HOURS OR WEEKLY 4.9.6 PTO (PUMP DISTRIBUTOR GEAR) AND OIL RESERVOIR - CHECK OIL LEVEL Legend for illustration Z 21657 (1) Oil level gauge (2) Oil filler plug (3) Breather filter (4) Oil collector reservoir for secondary oil pump drive shaft housings (5) Breather filter with oil level gauge (6) Main pump drive shaft housings (7) Oil level plug of main pump drive shaft housing (8) Oil filler plug with breather pipe of main pump drive shaft housing (9) Oil drain plug of main pump drive shaft housing (10) Oil drain plug of PTO gear CHECK OIL LEVEL OF PTO GEAR 1. Unscrew level gauge (1) and wipe it clean. 2. Insert gauge (1), but DO NOT screw in, see detail (A).
3. Remove level gauge and read the oil level. The oil level should be between the “MIN” and “MAX” mark. If necessary, add oil through filler opening (2) up to the “MAX” mark on gauge (1). NOTICE If the oil level is above the “MAX” mark, drain the oil down until the oil level is at the “MAX” mark. Too much oil in the pump distributor gear will cause aeration of the oil. 4. Insert gauge (1) and tighten securely. Remove breather filter (3). Blow out with compressed air from inside to outside and reinstall. CHECK OIL LEVEL OF OIL COLLECTOR RESER- VOIR (4) Remove breather filter with oil level gauge (5). The oil level should be between the “MIN” and “MAX” mark.
If necessary, add oil through the level gauge opening. Clean the breather filter and install. NOTICE If oil starts dropping out at breather (5), check oil seals of secondary pump drive shafts for damage. 325