Komatsu — 4.10.1 AIR CONDITIONING COMPRESSOR - CHECK DRIVE BELT TENSION

MAINTENANCE 4.10 EVERY 250 OPERATING HOURS OR MONTHLY 4.10.1 AIR CONDITIONING COMPRESSOR - CHECK DRIVE BELT TENSION Be sure to set the maintenance safety switch to 0 position before to start the checking procedure. Refer to page 149 for the location of the maintenance safety switch. In the 0 posi- tion the engine can not be started. Secure this position by inserting a padlock into the holes of the switch. Up to three padlocks can be attached to the holes provided.

Legend for illustration Z21658 (1) Refrigerant compressor (2) Electromagnetic clutch (3) Compressor carrier (4) Drive belts (5) Clamping bolt (6) Lock nut (7) Adjusting bolt for belt tension Check tension of each belt Remove the drive belt guard. The tension is correct if the belt can be depressed with 110 N (25 lb) force approximately 15 to 20 mm midway between the belt pulleys. Excessive belt tension causes undue wear on the bearings. After a new belt has been in use for approximately 20 minutes, check the tension and adjust again if necessary. NOTICE Always replace the belts in complete sets. Adjust belt tension 1. Loosen clamping bolt (5) 2. Loosen lock nut (6) 3.

Turn adjusting bolt (7) until correct belt deflection is obtained. Tighten lock nut (6) 4. Tighten clamping bolt (5) and check the belt adjustment. 5. Install the drive belt guard. 331 WARNING WARNING