MAINTENANCE 4.12 EVERY 1000 OPERATING HOURS OR EVERY 6 MONTH FILTER SERVICE Replace breather filter element Drain water and sediments from hydraulic oil tank Legend for illust. Z 21503 (6) Hand wheel of main shut-off valve located between suction oil tank and main oil tank To open the valve, turn hand wheel (6) CCW to the stop To close the valve, turn hand wheel CW to the stop A proximity switch located on the gearbox of the shut-off valve monitors the valve position. With the valve not fully open, a corresponding message will be displayed on the VHMS monitor in the operator’s cab. REMARK Before starting the engine, make sure the valve (6) is completely open.
(11) Breather filter Replace Element (C) of Breather Filter (11). 1. Remove nut (A). 2. Remove cover (B). 3. Remove filter element (C). 4. Insert new filter element and reassemble the breather filter (15). Drain Water and Sediments Drain water and sediments with machine standing an level ground and when machine was out of operation for some time. Refer to Operation section 3.18 for evacuation procedure. 417