Komatsu — 4.12.2 HYDRAULIC SYSTEM - FILTER SERVICE

MAINTENANCE 4.12 EVERY 1000 OPERATING HOURS OR EVERY 6 MONTH FILTER SERVICE Clean or replace Pressure Oil Filter Elements, illust. Z 23026 NOTICE If a fault message "Trouble oil filter...." is displayed, stop the engine and clean or replace element of the respective pres- sure filter. Legend for illust. Z 23026 (1) Central control and filter carrier (2) Pressure oil filter, hydraulic oil cooler fan drive (3) Pressure oil filter, pump regulation and pilot circuit (4) Pressure oil filter, PTO gear lubrication (5) Pressure oil filter, engine radiator fan drive REMARK The filter element of pressure oil filter (4) for PTO lubrication can not be cleaned. This filter element must be replaced.

Clean or replace filter element (F) as follows: 1. Place working attachment on the ground and shut-off the engine. Relieve pressure in the hydraulic system with several move- ments of the control levers. 2. Place a suitable container below the filter in order to collect outflowing oil. 3. Remove plug (A) and drain the oil. 4. Unscrew case (C) of the respective filter and clean the filter case. NOTICE Carefully inspect elements for damage. Always install new elements if ruptures or other damages are found. 5. Remove element (F) and clean. Take care not to contaminate the "Clean" inside of the element when flushing. 6. Inspect O-rings and back-up ring. Replace if necessary. 7.

Install drain plug (A) with new packing ring (B). 8. Lubricate the thread at the filter head and at filter case (C) with multi-purpose grease K2K. 9. Insert the cleaned element or a new element (F) with new O- ring (G). 10. Fill the case (C) of hydraulic oil filters (2, 3 and 5) half way up with clean hydraulic oil. 423