Komatsu — 4.14.2 TRAVEL GEARS, BRAKE AND MOTOR ADAPTER HOUSINGS MANUFACTURED BY "L&S"- CHANGE OIL

MAINTENANCE 4.14 EVERY 3000 OPERATING HOURS HOWEVER AT LEAST ONCE A YEAR BRAKE HOUSINGS - CHANGE OIL See illustration Z 20436 NOTICE The brakes must be released for draining the oil. 1. Place wedges at front and rear side of both crawlers. 2. Start the engine and lower the bucket onto the ground. 3. Have a second person for control in the operator’s cab. 4. Remove parts (6, 8 and 9) and drain the oil. 5. After the oil is completely drained install plug (8). 6. Shut down the engine/motor. 7. Fill in fresh engine or hydraulic oil up to level openings (6). Install plugs (6 and 9).

DO NOT fill the brake housings with the engine/motor run- ning, otherwise the brake housings will be overfilled leading to overheating and severe damage to the brakes. NOTICE Be sure to fill the brake housings and motor adapter hous- ings with engine oil or hydraulic oil as specified on page 265. MOTOR ADAPTER HOUSINGS - CHANGE OIL 1. Remove parts (5 and 7) and drain the oil completely. 2. Check breather filter, mounted inside center frame, and clean as necessary. 3. Install drain plug (7) and fill-up oil to level opening (5). Recon- nect breather filter hose line to level and filler opening (5). 463 CAUTION CAUTION