MAINTENANCE 4.16 WELD REPAIRS GENERAL INFORMATION Welding operations can cause damage to electronic components. (Computers, Control Units, Sensors etc.), in case the welding cur- rent goes through these units. Therefore protective measures are necessary before any weld repair is started. GENERAL PROTECTIVE MEASURES A Observe the prevailing safety and fire prevention regulations. Before any weld repair is started, a survey should be made of the area and all safety considerations satis- fied such as fuel tanks, oil lines, electrical cables and synthetic materials. B Attach the welding ground directly to the part that is being repaired. Do not allow welding current to go through bearings.
Welding current could arc the bearings, resulting in severe damage to the bearing. WELD REPAIRS ON MAJOR COMPONENTS OF THE SHOVEL COUNTERWEIGHT The chambers of the counterweight are filled with a mixture of concrete, granulated ore and steel pellets. This mixture can create explosive gases which will accumulate in the chambers of the counterweight. Before any welding, flame- cutting, grinding or drilling procedures are carried out on the counterweight it is vital to expel these gases from the coun- terweight chambers. Failure to properly expel the gases from the counterweight chambers can result in an explosion with serious personal injury or death.
Follow the instructions given in PARTS & SERVICE NEWS No. AH04518 for expelling the gases from the counterweight chambers. Legend for illustration Z 21707 (1) Undercarriage, refer to page 479 for protective mea- sures. (2) Loader attachment, refer to page 481 for protective measures. (3) Superstructure, refer to page 483 for protective mea- sures. 477 WARNING WARNING