Komatsu — 3.3.5 AUTOMATIC FLOAT POSITION FOR BOOM AND STICK

OPERATION 3.3 OPERATOR’S CAB - CONTROLS EURO Control Pattern Legend for illustration Z25459 (1) Control lever for stick and swing machinery (2) Control lever for boom and bucket (3) Push button for deactivation of boom float position (4) Push button for deactivation of stick float position (5) Toggle switch for engine speed selection Low idle – High idle (6) Push button for Truck counter number 1 (TR1) For counting loaded trucks press this button. The total number of trucks loaded is shown on the VHMS monitor field TR1, refer to page 98 for more information. A second truck counter switch is located on the control panel, refer to page 89 for more information.

NOTICE The push button (6) has a second function. When the Vehicle Health Monitoring System is switched to the PM CLINIC group within the SERVICE MENU, selected PM CLINIC data can be frozen by pushing button (6). Frozen data can then be stored in the PM CLINIC MEMORY. For more information refer to the SERVICE MANUAL VHMS-System. (7) Swing speed switch. This switch has two positions: Left side down - Normal swing speed. Right side down - Increased swing speed. It is recommended to use the higher swing speed for slewing angles greater than 90°.

(8) Signal horn button (9) Pedal for closing the bottom dump bucket (10) Pedal for opening the bottom dump bucket (11) Travel control pedal, left track forward - reverse (12) Travel control pedal, right track forward - reverse (13) Slew brake pedal 3.3.5 AUTOMATIC FLOAT POSITION FOR BOOM AND STICK The Shovel operates automatically with the float position for boom and stick activated. That means the lowering movement of boom and stick is always done in the float position. To deactivate the float position, press button (3) for boom and/or (4) for stick, and keep depressed as long as the float position shall be deactivated. When releasing the buttons the float position is activated again.

For more information See "WORKING WITH THE ATTACHMENT" on page 202. 85