Komatsu — 3.3.6 OPERATOR’S CONSOLE

OPERATION 3.3 OPERATOR’S CAB - CONTROLS Switch Board Legend for illustration Z25964 (1) Key operated main switch After switching OFF main switch (1), wait at least 3 minutes before switching OFF the battery main switches. VHMS needs this period for saving data. If batteries are switched OFF before this time period is over, data will be lost. (2) High level alarm: Automatic engine shutdown . The high level alarm (2) will sound approximately 10 seconds before an automatic engine shutdown occurs and will continue to sound during the 10 second period. At the same time a blinking message *SHUTDOWN* will be displayed on the VHMS screen.

Use the time period to move the machine to a safe place and lower the attachment to the ground. Inform service about the shutdown condition. (3) Strike button, emergency shut down of the engine and pilot control system cut out. In case of emergency push in this button to stop the Diesel engine and to cut out the pilot control circuit. DO NOT use for normal stopping procedure. For releasing the switch, turn and pull-up the strike button. (4) Engine WARNING lamp (Yellow). This lamp is used to monitor engine out- of-range condition, in case the VHMS Monitor fails to function.

When this lamp illuminates, the engine can still be operated until end of shift, but it can lose some system features which sometimes results in power loss (derate condition). Inform Service about the engine problem. (5) Engine STOP lamp (Red). This lamp is used to monitor engine out-of- range condition, in case the VHMS Monitor fails to function. When this lamp illuminates, stop the engine operation in a safe manner immediately. The engine monitoring system CENSE or the electronic control module ECM will initiate automatic engine shutdown due to serious engine prob- lem. Inform Service about the engine failure.

(6) Rotary switch ”Engine START” (7) Rotary switch ”Engine STOP” (8) Switch for warning beacon on cab roof (9) Switch for interior illumination 89 CAUTION WARNING WARNING