OPERATION 3.3 OPERATOR’S CAB - CONTROLS Switch Board (continued) Legend for illustration Z25964 (10) Switch for main working lights (11) Toggle switch, swing parking brake 0 - Parking brake released - UP 1 - Parking brake applied - DOWN. The parking brake should only be applied with superstructure at complete standstill, except in case of emergency. Refer to page 200 for more information. (12) Enable switch for hydraulic service arm operation. Set this switch to ON position ”1” before lowering the service arm. With this switch in ON position, the pilot control system is made inoperative and the hydraulic swing brake is applied.
After completion of replenishment procedure, swing back the service arm to its home position and set switch (12) to OFF position ”0”. (13) Switch, manual actuation of central lubrication sys- tem (14) Switch, windshield washer (15) Switch, mirror heating (16) Switch, cab ventilation blower. Blower runs with low speed, even with switch in -0- position. (Cab pres- surizing prevents ingress of dust).
(17) Switch, manual actuation of swing ring gear pinion lubrication system (18) Switch for upper and lower windshield wiper 0 - Off 1 - Interval stage 2 - Slow stage 3 - Fast stage REMARK If a trouble condition of the windshield wipers occurs, remove lower wiper and check the limit switch contacts (53a and 31b) on both wiper motors. Reset the wiper system by actuating switch (S145) on the X2 switch board. See page 157 for location of the switch. 91 CAUTION CAUTION