Komatsu — 3.3.7 INTERFACE PANEL FOR DIAGNOSTICS

OPERATION 3.3 OPERATOR’S CAB - CONTROLS 3.3.7 INTERFACE PANEL FOR DIAGNOSTICS Legend for illustration Z25563 (1) Interface panel on rear operator’s console (X36) Data link connector for programming the VHMS monitor (X27A) Data link connector for download of VHMS memory data (X13) Data link connector for Electronic Tool connection to the electronic pump control system RC4 (S53) Enable switch for CENSE and QUANTUM diagnos- tic. For download of engine data and for program- ming the CENSE and QUANTUM ECM stop the engine and set main key switch to off position, then turn on switch (S53).

For checking active fault codes of the engine via service lamps H94, H95 and H96 located on switch board (X2) in the cab base use the same procedure described above. Refer to page 161 for more information. (X38) Data link connector for Electronic Tool connection to the ECM of the engine monitoring system CENSE and the electronic controlled fuel system QUANTUM. (2) Portable fire extinguisher. Observe the local Fire Prevention Regulations in regard to number, size and location of portable fire extinguishers. Make sure the fire extinguisher is always charged and ready for use. 95