MAN — Replacing valve seat insert

Replacing valve seat insert Installing valve seat insert Fig. 4 Heat cylinder head to approx. 80 _ C (175 _ F) in water bath. Cool new valve seat insert to approx. −200 _ C (−330 _ F) and insert it in the cylinder head. Carry out check by driving it in until the stop is re- ached using pressing tool. Install valve guides. Note: When the valve seat inserts have been changed, the valve seats must be re- worked. 4 Note: D After temperature equalization, machine valve seats. D After machining, clean cylinder head and check for leaks using leak testing device.

D If the cylinder head is excessively heated (above +200 _ C, +390 _ F) the core hole covers (end covers) loose their tightness and must be exchanged. D To do this, clean core holes, blow out channels and press in new core hole covers with “LOCTITE 648” and pressing mandrel (special tool, see page 173). 117