MAN — Reworking valve seat

Reworking valve seat Fig. 4 Release Jaccard lever, place magnetic flange flush on the clamping plate and set the height so that the tool does not contact the valve seat. Set toggle switch to position 1. Tighten the Jaccard lever. 4 Fig. 5 Machine the valve seat by turning the driving crank evenly in clockwise direction and simultaneously operating the feed nut. Caution: During the machining process turn the driving crank vigorously and evenly but un- der no circumstances against the direction of turning, as otherwise the carbide cutting edge may break. 5 Fig. 6 Once the valve seat has been expertly machined, reduce the working pressure of the tool by 2-3 rev- olutions without feed motion.

During these revolutions turn the feed nut 2-3 rev- olutions back. Press toggle switch briefly to position 2 to lift the magnetic field. Now move the whole Mira unit out upwards and insert it into the next valve guide, repeating the centering operation. Use the same tool settings for all intake and all exhaust valve seats (see below). 6 Fig. 7 2 1 Observe specified seat angle. 1 Exhaust, total angle: 90 _ , tool setting: 45 _ 2 Inlet, total angle: 120 _ , tool setting: 30 _ Repeat the chip-removing machining process until the valve seat is clean and free of pores. 7 119