Repairing tachometer drive (angle drive) Removing broken driving dog Fig. 1 The tachometer drive (angle drive) is located on the engine front side and connected with the cam- shaft. Remove angle drive. 1 Fig. 2 Before drilling out the broken driving dog seal the space between camshaft (1) and cover (2) with grease to prevent metal chips getting into the engine. 2 1 2 Fig. 3 Drill out broken driving dog, ensuring exact cen- tring (driving dog material is very hard). Initial drilling with 4 − 4.5 mm drill, final drilling with 6.5 mm drill. After a 1 − 2 mm hole has been drilled, grease drill completely without fail so that drilling chips will be collected. Proceed by the millimetre only.
Pull drill out of the hole again and again, wipe off chips and regrease drill. ОО Note: The driving dog is not fully inserted in the dead-end hole in the camshaft. Take care when pushing the drill through (risk of drill breaking). 3 Fig. 4 Cut M8 thread into driving dog. Grease an M8 x 70 or M8 x 80 cylinder bolt and screw it into the dead-end hole until stop is reached. Push rest of driving dog out of the bore by carefully continuing to turn. 4 129 Î Î