Replacing cylinder liners Installing cylinder liners Fig. 9 Oil new O-rings for lower seal (144x4) and insert them in crankcase. Oil new O-rings for upper seal (138x2) and roll them from below on to the cylinder liner and into the grooves. Do not overstretch the O-rings. Note: No grease or sealing agents of any kind must be used for installing cylinder liners and O-rings. 9 Fig. 10 Apply thin coat of engine oil to cylinder liner in the area of the upper and lower O-ring. Apply thin coat of engine oil to lower O-rings in the crankcase. Insert cylinder liners into crankcase and push them down by hand.
Place clean metal plate on liner and exert uniform downward pressure until the liner is seated in the crankcase recess. 10 If a perceptible resistance can be felt in this oper- ation, the O-rings are no longer in their proper place. Reposition O-rings and insert cylinder liner again. Note: After fitting the cylinderliners ensure that the O-rings are in the correct position by checking the liner protrusion. Use special tool (see page 172) and pro- ceed as follows: D Position press-on measuring plate with turned collar facing the liner using 2 fit- ting sleeves to centre plate. D Tighten 4 bolts (improvised:
collar bolt 51.90020-0270, length shortened to 90 mm) on the press-on measuring plate in stages and crosswise to 40 Nm. D Set dial gauge combination above press-on plate to “0” under preload rel- ative to the crankcase. D Measure cylinder liner protrusion at least at four points. 143