MAN — Removing and installing starter

Removing and installing starter Removing starter Fig. 1 Disconnect minus cable from battery or switch off battery main switch if fitted. Disconnect cable from terminal 31 (minus terminal, thick cable), terminal 30 (plus terminal, thick cable) and terminal 50 from starter. 1 Fig. 2 Remove mounting nuts (19 mm). Caution: A curved wrench is advantageous for the inner bolts (see Fig.). 2 Fig. 3 Take off starter. Check starter pinion for wear and that it can move freely. If necessary, clean piston using a brush dipped in fuel and regrease it. 3 Check flywheel gear ring for wear and damage.

Turn over engine by hand once, paying particular attention to the positions at which the engine finally stops; i.e. when the engine is switched off it always stops in certain positions. The starter pinion engages in these positions when the engine is started. For changing starter gear ring, see page 88. 145