Removing and installing power take-off for raw-water pump Installing power take-off for raw-water pump Fig. 7 Place timing case under a press on a suitable sup- port in a horizontal, tilt-resistant position. Align new bearing to correct seat in timing case. 7 Fig. 8 Press in bearing. For this purpose use suitable pressing die to en- sure that pressure is applied to the bearing outer ring and not to the bearing shaft. A tube with the following dimensions may be used as a pressing die: External diam. = 73 mm Internal diam. = 60 mm Length = 50−60 mm 8 Fig. 9 Hold drive shaft in vice stationary (see device in Fig. 2). Fit drive gear. Tighten collar nut to the specified torque of 390 Nm. 9 Fig.
10 Caulk collar of nut into the groove of the drive gear. Attach flywheel housing. 10 152