MAN — Removing and installing power take-off for hydraulic pump

Removing and installing power take-off for hydraulic pump Fig. 5 Remove rectangular cover on right−hand side of timing case cover. The PTO shaft is now visible. For better accessibil- ity we recommend removing the charge-air pipe on the right−hand side. 5 Fig. 6 Hold crankgear stationary. The picture shows a special tool to be attached to the inspection hole of the flywheel housing. 6 Fig. 7 Use ring spanner (special tool, see item 28 on page 169) to remove mounting bolt from drive gear. Caution: The bolt must not fall into the engine. 7 Fig. 8 Take off drive wheel and pull out bearing flange with drive shaft. 8 155