MAN — Changing fuel filter cartridge, bleeding fuel system

Changing fuel filter cartridge, bleeding fuel system Changing fuel filter cartridge Only when engine is switched off Fig. 1 Use tape wrench to loosen filter cartridge and re- move cartridge by hand. Fit a new seal. Lightly coat seal on the filter cartridge with fuel. Screw on filter cartridge and firmly tighten it by hand. D Loosen filter cartridge by means of tape wrench, unscrew it by hand and take it off D Moisten the seals on the new filter cartridge with fuel 1 D Screw on the filter cartridges and tighten them vigorously by hand Continuous operation (both filter halves in operation) D Bleed fuel system D Check filter for leaks Right-hand filter cut out Caution:

Used fuel filters are classed as dangerous waste and must be disposed of accord- ingly. Left-hand filter cut out 2 Change-over fuel filter Fig. 2 Where the changeover-type filter is installed, the servicing procedure is for the filter side requiring to be shut off with the engine running. During continu- ous operation, the selector lever should be placed in a position where both filter halves are in oper- ation. Caution: Do not leave selector lever in any inter- mediate position because this would be liable to interfere with fuel supply. If in doubt stop the engine to change the fuel filter. The filter cartridge is then to be exchanged as de- scribed under parallel box filter (Fig. 1). 47