MAN — Removing and installing vibration damper, changing front crankshaft seal

Removing and installing vibration damper, changing front crankshaft seal Removing vibration damper D Turn engine to TDC. In 8-cylinder engines cylin- der 1 is at ignition TDC if the valves of cylinder 6 are in crossover. This ensures that in subse- quent assembly work the graduated scale will be in the correct position. D Relax and remove V-belt; see page 149 Fig. 1 Block the crankgear. The picture shows a special tool to be fitted at the inspection hole of the flywheel housing. 1 Fig. 2 Remove V-belt pulleys. 2 Fig. 3 Loosen mounting bolts on vibration damper. Note: Owing to the high tightening torque a rein- forced socket in conjunction with a 1/2” tool is required. 3 Fig.

4 Remove two mounting bolts which are opposite each other and screw in mandrels (M16 x 1.5) Remove all other bolts. Take off vibration damper. Caution: The vibration damper is susceptible to shocks. Take hub and oil splash ring off the crankshaft. 4 82