Removing and installing vibration damper, changing front crankshaft seal Fig. 13 Fit cover А with new seal Б . The cylinder pins В provide better guidance for the cover. These will ensure that the seal is not too easily damaged when the cover is put on. Tighten screws (13 mm) to specified torque. 1 2 3 13 Installing vibration damper Fig. 14 Push hub and oil splash ring on to crankshaft. 14 Fig. 15 Place vibration damper on two guide pins (M16 x 1.5). Ensure that the position of the grad- uated disc relative to the crankshaft is correct. 15 Fig. 16 Tighten mounting bolts (24 mm) to specified torque. Note:
Owing to the high tightening torque a rein- forced socket in conjunction with a 1/2” tool is required. 16 85