Exchanging bearing race Exchanging bearing race D Remove flywheel, see page 87 Fig. 1 If the shaft seal on the flywheel end is to be ex- changed, it is advisable to exchange the bearing race too. Snap the bearing race to be exchanged by apply- ing a blow with a hammer. Danger: Wear goggles and working gloves for pro- tection against metal fragments. 1 Note: Do not damage flywheel. Do not use a chisel. Fig. 2 Insert the new bearing race into the pressing man- drel (special tool, see page 167, item 14) so that for the subsequent assembly the internally cham- fered side faces the flywheel. Carefully heat the pressing mandrel with the bear- ing race.
The installation temperature for the bear- ing race is about 150 _ C (300 _ F). 2 Fig. 3 Press in bearing race until it stops. 3 Fig. 4 Seal the gap between the flywheel and the bearing race with “Antipor 46”. 4 90