Group 65 Ignition System REPLACE BREAKER POINTS AND CONDENSER—B43E, B43G, B48G, AND T260 ENGINES NOTE: On later engines, the condenser is located on side of air filter bracket. M37242 -UN-25JAN90 1. Remove air cleaner assembly. (See Remove Air Cleaner in Group 05 in this manual.) 2. Remove breaker point cover. M98,2065K,1 -19-02FEB87 3. Remove two set screws to remove breaker points. 4. Loosen screw (A) to disconnect coil and condenser leads. 5. Remove screw (B) to remove condenser. M37243 -UN-25JAN90 6. Install new condenser and point assembly. Apply thread sealant on threads of set screws and fasten breaker points. Early Point Assembly Shown M98,2065K,2 -19-05NOV85 7.
Check breaker point gap. Turn engine flywheel until points are at their widest gap. Adjust gap to 0.41 mm (0.016 in.) using a flat feeler gauge. M37244 -UN-25JAN90 M98,2065K,3 -19-05NOV85 65 1 CTM2 (19APR90) 65-1 16, 18, 20 & 24HP Onan Engines AllTractorManuals.com 130495