12. OPERATION J : Adjusting height of armrest (Depending on the specification, this may not be installed) Remove cap 6 , then loosen the nut. Set to the desired height, then tighten the nut and install the cap. Amount of adjustment: Up: 16 mm (0.6 in) Down: 24 mm (0.9 in) It is also possible to make the armrest spring up. K : Adjusting angle of armrest (Depending on the specification, this may not be installed) Turn knob 7 to adjust the angle of the armrest. Amount of adjustment: 40 degrees (front: 30 degrees; rear: 10 degrees) L : Lumbar support Turn knob 8 to the right or left to give suitable tension to the lumbar region. M :
Adjusting hardness of suspension damper Operate knob 9 to adjust the damping force of the suspension damper. If knob 9 is moved to face the outside of the seat a , the damping force becomes stronger; if the knob is moved to face the inside of the seat b , the damping force becomes weaker. Amount of adjustment: 5 stages 2-48