Komatsu — 24.2 WHEN REQUIRED

24. SERVICE PROCEDURE 24.2.13 ADJUST PARKING BRAKE WARNING When adjusting the parking brake, be sure to put blocks 1 under the tires to prevent the machine from moving. When carrying out the adjustment, raise the air pressure high enough to prevent the parking brake from being applied automatically, and be sure to hang a caution tag on the turn signal lever to prevent any other person from operating it. Take care not to get oil or grease on the brake pad and the disc surface. If the parking brake fails to work properly, adjust as follows. 1. Release the parking brake. 2.

Turn adjustment screws 2 and 3 on the side face of the slack adjuster until parking brake pad 4 and disc 5 on both sides are in contact. Turn adjustment screw 2 counterclockwise and adjustment screw 3 clockwise. 3. Turn adjustment screw back 1/2 turns (turn adjustment screw 2 back clockwise and adjustment screw 3 back counterclockwise). As a result, the total clearance between parking brake pad 4 and disc 5 on both sides is approx. 1.06 mm (0.042 in). Check the lining for wear and replace the pad if the thickness of the lining is reduced to less than 3 mm (0.12 in). Ask your Komatsu distributor for replacement of the pad. 3-37