Komatsu — 24.2 WHEN REQUIRED

24. SERVICE PROCEDURE 24.2.18 REPLACE FAN BELT, ADJUST AUTO-TENSIONER Replace the blet if the V-belt contacts the bottom of the pulley groove, or if the fan belt is lower than the outside edge of the pulley, or if there are any cracks, peeling, or other damage to the V-belt. Replacement 1. Loosen adjustment bolt 1 , then remove yoke 3 with locknut 2 still installed. There is danger of losing parts, so do not remove bolt 1 from bracket 4 . 2. Insert a bar of a length of approx. 50 cm (20 in) into hole 7 (ш24) of the tension pulley bracket, and pull forward strongly. AE137010 3. The spring is extended and the tension pulley 5 moves inwards, so remove the old belt and replace it with a new one.

Always replace the V-belt as a set (5 belts). AE137020 Adjustment 1. Install adjustment bolt 1 and locknut 2 to yoke 3 . 2. Tighten adjustment bolt 1 until the clearance is 0 mm (0 in) between the end of the oblong hole of yoke 3 and pin 6 of tension pulley 5 , then tighten a further three turns. Tighten locknut 2 to hold in position. 3. Run for one hour, then check the clearance between the end of the oblong hole of yoke 3 and pin 6 of tension pulley 5 . If there is any clearance, repeat Step 2 to adjust again. AE137040 If the fan belt makes any abnormal noise, adjust in the same way. 3-42