24. SERVICE PROCEDURE 24.7.3 REPLACE TRANSMISSION OIL FILTER ELEMENT WARNING Apply the parking brake, and lock the front and rear frames with the safety bar and pin. The oil is at high temperature immediately after the machine has been operated. Wait for the oil to cool down before carrying out maintenance. Prepare a container to catch the drained oil 1. Loosen bolt and open the side panel. 2. Set the container to catch the oil under the filter case. 3. Remove drain plug 3 at the bottom of the filter case, and drain the oil. After draining the oil, tighten the plug. 4. Hold case 2 and loosen hexagon part 1 of case, then remove case 2 . 5. Remove the element, and clean the inside of the case.
6. Replace the filter gasket and O-rings with new parts. Coat the gasket and O-rings with clean engine oil before installing. 7. Assemble the new element, set it in the case, then install with case nut 1 . Tightening torque for drain plug: 49 – 58.8 N·m (5 – 6 kgf·m, 36.2 – 43.4 lbft) Tightening torque for case: 58.8 – 78.5 N·m (6 – 8 kgf·m, 43.4 – 57.3 lbft) 8. Run the engine at idling for a short time, then check that the oil is at the correct level. For details, see “24.2 WHEN REQUIRED”. 3-64