29. HANDLING JOYSTICK STEERING SYSTEM (Air suspension seat (Manufactured by GRAMMER)) An air compressor built into the seat is used for adjustment C and D , so turn the engine starting switch to the ON position before starting the adjustment. NOTICE There is danger of damage to the air compressor, so do not keep lever 3 operated continuously for more than 1 minute. A : Fore-and-aft adjustment Move lever 1 up and move the seat to the desired position and release the lever. Fore-and-aft adjustment: 210 mm (10 mm x 21 stages) (8.3 in (0.4 in) x 21 stages)) B :
Adjusting seat angle Move lever 2 up, move the seat cushion at the front up or down to set to the desired position, then release the lever. Amount of adjustment Forward tilt: 3 degrees Rear tilt: 11 degrees C : Adjusting seat height The seat height adjustment uses an air system, and it can be adjusted steplessly. When adjusting the height, pull lever 3 up fully or push it down fully (when pulling it up, pull it until a click is felt). When the seat is set at the desired height, release the lever. If the lever is kept pulled up, the position where the seat does not rise any further is the maximum height.
When the seat reaches the maximum height, the suspension automatically goes down slightly to secure the amount of movement of the lever. If the operator raises his body from the seat or changes the amount of weight applied to the seat during adjustment, the air in the suspension may be discharged. Amount of adjustment: 80 mm (3.2 in) REMARK If lever 3 is pulled up further from the maximum height, the air compressor may make a sound of actuation but the seat may not rise. This does not indicate any abnormality. If this happens, the air compressor will stop automatically after approx. 8 seconds. It will also stop if lever 3 is pushed down. 5-18