30. MAIN MONITOR FAILURE DISPLAY If an error code is displayed on the main monitor portion (normally the speedometer display) of the machine monitor, follow the corresponding table when carrying out the selfdiagnostic troubleshooting below. 30.1 MAIN MONITOR FAILURE DISPLAY (Contents of operator’s actions against each error code) 5-21 Action by operator Normal work possible with manual operation Normal work is possible in manual mode. (If joystick is installed, normal work is possible with steering wheel in manu- al shift mode.
Stop machine, turn starting switch OFF, do same as above, then call service Alarm buzzer No Yes Option Joystick control system Condition of machine Returns to neutral (Steering with steering wheel can be selected.) – – – – Problem system Disconnection, short circuit, or short circuit with ground in joystick FNR signal system (or L, R signal system) – – – – Travel damper control system Condition of machine – – – – – Problem system – – – – – Transmission control system Condition of machine Does not shift gear auto- matically (switches to manual gear shifting) Engine speed taken as 2100 rpm (there is gear shifting shock.
Gear does not shift in auto-shift mode, however.) Becomes neutral, travel impossible (judges controller input as N) Becomes neutral, travel impos- sible (ECMV output OFF) Becomes neutral, travel impos- sible (ECMV output OFF) Problem system Disconnection in travel speed sensor system Disconnection, short circuit, or abnormality in engine speed sensor system Disconnection, short circuit with ground, or short circuit in shift lever system Disconnection, short circuit with ground, or short circuit in F, R solenoid signal system Disconnection, short circuit with ground, or short circuit with speed range solenoid signal system Error code E00 CALL