31. HANDLING AUTO-GREASING SYSTEM 3. Method of bleeding air from pressure switch This work shall be performed by two persons. 1) Open transmission inspection cover 5 at the rear of the cab. One person removes pressure switch 7 from block 6 , then stays there. 2) The other person presses the auto-greasing switch to start the grease pump. 3) Discharge the grease containing air (milky white in many cases) from the block 6 . If normal grease comes out, stop the grease pump. 4) Install pressure switch 7 to block 6 . (Check that grease is not leaking.) 4. Method of bleeding air from supply line This work shall be performed by two persons.
1) One person removes supply line pressure gauge 8 from block 6 , then stays there. 2) The other person presses the auto-greasing switch to start the grease pump. 3) Discharge the grease containing air (milky white in many cases) from the block 6 . If normal grease comes out, stop the grease pump. 4) Install pressure gauge 8 to block 6 . (Check that grease is not leaking.) NOTICE If air is left in the circuit, the grease pressure will not rise to the specified level or will take a long time to rise to the specified level, and the injector will not work normally. 5.
Filling branch lines (Injector - Pin) with grease Remove cap A of filler fitting 0 of injector 9 , then fill the all branch lines with grease by using a hand grease gun. 5-26